How to prevent UV flatbed printer lines from being bitten in spring

Some time ago, when I went to the customer's on-site after-sales service, I found that the line of the uv flatbed printer was obviously bitten by a mouse, which caused the machine to stop working and stop production. It should be noted that in the spring of each year, rats enter the peak of reproduction. During this period, the activities of rats will be more frequent, and most of them move at night, while most of our companies are resting at night. If you do not pay attention to daily protection, it is easy to cause the line to be bitten. If some carelessness is not cut off, it will directly cause the line to burn.

Method for uv flatbed printer circuit to be bitten off

So how to prevent the uv flatbed printer line from being bitten?

Precaution

1. In daily work, if spider webs are found, they should be removed in time, the waste inside the workshop should be cleaned daily, and the waste bucket should be cleaned daily;

2. The maintenance department is responsible for maintaining the firmness of all doors and windows in the production area. During the installation of equipment or water pipes, any cracks or holes in the surrounding walls will be repaired in time;

3. Do a good job of preventing rats in the production workshop, install a net cover at the drain outlet, and all the water outlets in the workshop are equipped with iron nets to prevent rats from getting into people.

Control measures

1. Set up rodent-killing points in the factory and production areas, and set up sticky mouse boards and mouse traps at the rodent-killing points;

2. Install a rat-proof board at the entrance of the workshop.

Personnel specification requirements:

1. Do not eat or eat snacks in the uv flatbed printer workshop. If it is unavoidable, please do not put food residues and waste food in the trash can. The spilled rice dishes and spilled oil must be cleaned up;

2. Do not store snacks such as fruits, biscuits and candies in the drawer of the desk where the uv flatbed printer is controlled;

3. After the operator turns off the equipment every day, pay attention to power-off protection and check whether there is food residue inside and outside the machine.