UV Violet Printer Control System

It is a system used to control the work of the entire light curing machine.

It is worth noting here: 1. The control of the fan is best controlled by the temperature automatically (mentioned in the previous section), because the control by the person may have omissions and not accurate enough.

2. The light should be turned on when starting up, and then the fan should be turned on after 2 to 3 minutes (when the fan is not temperature controlled).

3. After shutdown, the fan should continue to run until the lamp and the cabinet cool down.

4. The second start must wait until the lamp tube is completely cooled before starting. Conveying system It consists of speed-regulating motor (or frequency-conversion speed-regulating), conveying mesh belt, chain (or conveying roller). Attention should be paid to the adjustment of speed. The curing speed should be considered from two aspects, one is full curing, and the other is curing at the best speed. The best speed selection method is: first pass the product through the UV curing device at a certain speed, if it is cured, then accelerate the speed until the ink layer of the product passed through the UV curing device cannot be cured. The speed at this time multiplied by 0.8 is the optimal speed. In addition, you should pay attention to the use time of the lamp, because as the energy of the Uv lamp decay, the speed should also be slowed down.