How To Do The Daily Shutdown And Moisturizing Work Of The Uv Flatbed Printer?

1. Print the status of the print head; make sure that the print head is in good condition before the machine is machined. If the print head is not in good condition, please execute the "Print Head Maintenance Process".

2. Turn on the flashing mode; it is recommended that the machine stay powered on in daily standby mode, the computer is not turned off, and the control software opens the "flashing spray" state; only turn off the uv light.

3. Close the ink valve; when the machine needs to be powered off, the ink valve needs to be rotated 45 degrees to close the ink valve.

4. Close the software; before the machine is powered off, first normally close the control software to save the software data, and then turn off the power.

5. Power off the machine; press the "Power Off Switch" to power off the machine, turn off the main power switch, and then dial the power plug of the machine.

6. Spray head moisturizing treatment; wrap the stretch film with a plate or foam the size of the nozzle bottom plate, then place the dust-free cloth on it, pour moisturizing solution, let the dust-free cloth completely wet, and then put it under the nozzle bottom plate .

7. Soak the nozzles; press the ink cart on the dust-free cloth soaked with the moisturizing liquid. Note that each nozzle must be able to press on the dust-free cloth to ensure that the nozzles are in a moisturizing state.

8. Moisturizing is complete. The nozzle should not be too tight on the lint-free cloth, just soak in the moisturizing liquid, and the moisturizing is complete.