Some Tips For Using Uv Printer

There are many methods in the whole process of applying UV printers, but what are the practical methods? Today, the editor will give everyone a detailed introduction to the simple tips for the application of uv printers.

1. When moving the UV printer, you can't lift the copier service platform to move it, just hook the bottom of the device to the position of the housing to complete the movement.

2. When many customers use the UV printer at a time, they feel that the USB socket cable is not easy to plug in. In fact, if you lower it after connecting it to the power supply, it will be very easy to connect.

3. How to add ink to UV printer. Generally speaking, the UV printers we see today are only two ink supply methods, one is a separate printer cartridge, two continuous ink supply system software, but these two ink supply systems have a set of similar working components. Printer cartridges, nozzles, cleaning modules, ink tubes, waste ink bottles. When refilling ink or when the ink tube is clogged, you can apply a general medical equipment injection needle to vacuum at the bottom of the printer cartridge until ink enters the injection needle, or draw ink from the ink tube on the waste ink bottle stopper still alright.

4. It is very easy to eliminate static electricity. If an external wire is connected in series to the watch case strap of a metal material, then the external wire is grounded.

5. When the ink drop occurs on the nozzle, we can solve it according to the situation. One is to clean up the sealing of the silicone ring of the module if it is loose or damaged, so you can immediately remove and replace the silicone sealing ring. The other is that ink droplets collect on the bottom of the nozzle after the nozzle is hit. At this time, everyone should use cotton wool to scrub the bottom of the nozzle.

6. Adjust the aspect ratio of UV printer. Generally, the most fashionable UV printers on the market use infrared induction to check the aspect ratio of the block. The block must be placed before the copy command is sent. If the surface of the copied object has convex and concave conditions, be sure to pay attention to the adjustment before copying. The aspect ratio of the print head and the copy product to prevent damage to the print head.